"FREE" WITH EVERY ORDER OF MAX SEAL TUBES.
Easy install/replace tool. This easy to install tool grabs each tube without scratching or scuffing the tubes surface. We have been using our install tool for over 20x years and as a gift to you we are going include one for free! A $19.99 value!
MAX SEAL Tubes are made here in USA and are used on every LowBugget built engine. We don't want our engines to leak so we only use MAX SAEAL Tubes. Made from Top quality 6061 T6 aluminum, with a billet finish then black anodized less than a mile from our shop! You will never buy another set of push rod tubes again!
Features include:
- Two piece spring tensioned tubing that expands and contracts with engine. The advantage to a two piece push rod tube is you can install after the heads have been installed.
- Can install on assembled engine to replace other bad brands tubes!
- Much larger opening for high lift camshafts and ratio rockers. The higher you lift the valve the more the pushrod moves or "swings" off centerline. Stock style tubes usually rub on the push rods causing unwanted noise and leaks. Not a problem with LowBugGet MAX SEAL Tubes!
- Dual USA made Viton (FKM) o-ring seals between the tubes that last, and "They do not leak"!
- Tube-End Seals are made from 100% real silicone. Each Tube End Seal is very soft, softer than stock original German seals on purpose to help each seal to conform to the original and aftermarket cylinder heads surface.
- Made in USA, the stainless steel backing washers for the larger diameter end that goes to the head side.
- Work with short engines and WIDE engines!
- Custom your name or your shop name at no extra charge (must order minimum of 3x sets).
How to assembly video click here.