"SLIP-IN'S"
94mm
pistons cut to fit into 90.5 or 92 mm bore case.
This
way you don't have to split the case to build a 94mm motor.
If you
have a 1776cc, 1835cc, 2007cc, 2110cc and want a
1915cc, 2054cc,
2165cc, 2276, but do not want to open the case or send out for
machine work than these custom machine piston and barrel kits are
for you. Only the bottom of each barrel is cut for clearance. This
is also a good idea on mag case with 10mm head studs as that usually
means a 14mm insert is used. So boring open for a 94mm barrel
might cut into the large insert. Not a good idea!
Leave the
case 90.5/92mm and still bore the heads 94mm.
This will not affect
reliability or longevity. Only the bottom of the barrel is trimmed
smaller on the outer diameter.
This way your case is nice and
thick at the base so no pulled head studs! This is not a new thing
and has been used of years.
Each set includes:
4x New
"Balanced" 94mm Mahle pistons.(A or B)
4x Mahle wrist
pins.
4x complete sets of Mahle piston rings.
4x sets of stock
wrist pin clips.
4x 94mm Machine down barrels cut to slip-into a
90.5/92mm bored case.
Tech
Help Info! (see pictures with red and blue arrows)
The Blue
arrows show
the step that is left in by some shops if the case is cut for
90.5 or 92 bore.
The Red arrows show
were you will need to hand clearance for the
94mm's piston skirt
lip.
If your case does not have the Blue step than
you do not need to hand clearance.
You will still have to have
your heads bored open for 94mm.
We can do this for you.